-
公开(公告)号:JPH01292945A
公开(公告)日:1989-11-27
申请号:JP12261588
申请日:1988-05-19
Applicant: SONY CORP
Inventor: YAMANOUCHI KIYOSHI , ONISHI KANJI
IPC: H04M1/27
Abstract: PURPOSE:To simplify the procedure of dial operation by registering the dial operation procedure of a contracted telephone company, reading this order when a telephone call is made, inserting the telephone number of an opponent destination to a read signal in a position, which is determined by the standard of the telephone company, and sending the telephone number through a NON-ID station to the telephone company. CONSTITUTION:A registering button 11 and an NCC button 12 are provided in a telephone set 10. The dial operation procedure by the standard determined by the contracted telephone company and the telephone number of the opponent destination, which is inputted when the reproduced call is made, are respectively registered. Then, when the telephone call is made, the recorded dial operation procedure and opponent destination telephone number are reproduced and the telephone opponent destination telephone number is inserted to the prescribed position of the reproduced dial operation order and sent to a telephone line. Thus, the operation procedure can be simplified when the telephone call is made through the station of an NTT (NON-ID station), which have a former type exchange, and an NCC.
-
公开(公告)号:JPS5966254A
公开(公告)日:1984-04-14
申请号:JP17686582
申请日:1982-10-07
Applicant: Sony Corp
Inventor: YAMANOUCHI KIYOSHI , NAKANO YOSHITOMO
CPC classification number: H04M1/64
Abstract: PURPOSE:To hardly set the automatic answering mode except the user and to satisfy the specification of the Nippon Telegraph and Telephone Public Corporation, by setting the automatic answering mode only with a call signal of an ON- time set sufficiently longer than usual case. CONSTITUTION:Timers 25-54 check if a call tone input is consecutive for 0.3sec. The presence of the call tone within 5sec in the past is checked, and when there exists no input, it is discriminated as the 1st call tone, and an output of the timer 54 triggers a timer 55. If the measuring time of the timer 55 is elapsed for 55sec is checked from the output of a latch 56. It is detected that 5sec are elapsed after the call tone is lost by the timer 53, an output of an AND gate 59 goes to H level, and an output of an automatic answering mode setter 67 goes to H level. The presence in the lag of a cassette is discriminated already, the tape is rewound up to the tape top and the operation in the automatic answering mode is started.
Abstract translation: 目的:除了用户以外,几乎不设置自动应答模式,并且满足日本电报电话公司的规格,仅通过设置足够长的通话时间的呼叫信号设置自动应答模式。 规定:定时器25-54检查呼叫音输入是否连续0.3秒。 检查过去5秒以内呼叫音的存在,当不存在输入时,将其识别为第一呼叫音,定时器54的输出触发定时器55.如果定时器55的测量时间 从锁存器56的输出检查55秒。检测到在定时器53的呼叫音失去之后经过了5秒,与门59的输出变为H电平,并且自动输出 应答模式设定器67进入H电平。 已经区分了盒式磁带的滞后状态,磁带被倒回到磁带顶部,开始自动应答模式的操作。
-
公开(公告)号:JPS5412808A
公开(公告)日:1979-01-30
申请号:JP7814177
申请日:1977-06-30
Applicant: SONY CORP
Inventor: TANAKA KOUICHI , YAMANOUCHI KIYOSHI , YONETANI SHIGEO
IPC: G11B15/087 , G11B15/02
Abstract: PURPOSE:To enable the control signal of the next recording to be detected within the automatic stop time extended in rewinding playback after plural times of recording by subsequently extending the first automatic stop time in recording after automatic stopping.
-
-