-
-
-
-
-
Patent Agency Ranking
公开(公告)号：KR1019910004806B1
公开(公告)日：1991-07-13
申请号：KR1019880007346
申请日：1988-06-17
CPC classification number: H04Q3/0025 , H04Q2213/13141 , H04Q2213/13167 , H04Q2213/13176
Abstract: The method is for relating the level functions of the signalling transfer point and for assigning the signalling link selection (SLS) value to the level 2 signal link to improve the efficiency of teh signal network signal networks (L3) are connected to communicate mutually and signal links (L2) are connected to the signal neworks (L3) respectively. clusters (C) are formed by connecting signal data links to the signal links (L2) one by one and the clusters are grouped by maximum F numbers. SLS values are assigned to the signal links differently according to the clusters and the F numbers of signal links are assigned by same SLS value.
Abstract translation: 该方法用于将信令传送点的级别功能与用于将信令链路选择（SLS）值分配给级别2信号链路相关联，以提高信号网络信号网络（L3）相互连接的信号和信号的效率 链路（L2）分别连接到信号纽约（L3）。 通过将信号数据链路逐个连接到信号链路（L2）而形成簇（C），并且通过最大F数对簇进行分组。 SLS值根据簇分配给信号链路，并且信号链路的F数由相同的SLS值分配。
-
-
公开(公告)号：KR100411251B1
公开(公告)日：2003-12-18
申请号：KR1020010074723
申请日：2001-11-28
Applicant: 한국전자통신연구원
IPC: H04L12/28
CPC classification number: H04L45/50 , H04L45/12 , H04L45/122 , H04L45/24
Abstract: Disclosed herein is a constrained multipath routing method. In a Multi-Protocol Label Switching (MPLS) network, network conditions and traffic engineering requirements assigned to each link are set. The amount of assignments of each traffic requirement assigned to each link and a minimum value of each maximum link utilization α are calculated. A traffic rate (Xijkl) in which the degree of resource utilization is minimized in the minimized maximum link utilization α is calculated using the calculated amount of assignments of each traffic requirement and which is assigned to each link. Multiple paths corresponding to each traffic requirement and traffic division ratios of the multipath are calculated using the calculated traffic rate.
Abstract translation: 这里公开了一种约束多路径路由方法。 在多协议标签交换（MPLS）网络中，分配给每个链路的网络条件和流量工程要求被设置。 分配给每个链路的每个业务需求的分配量和每个最大链路利用率＆lt; 被计算。 业务速率（Xijkl），其中资源利用程度在最小化的最大链路利用率＆amp; 使用计算出的每个业务需求的分配量以及分配给每个链路的值来计算。 使用所计算的业务速率来计算与每个业务需求和多路径的业务划分比率相对应的多个路径。
-
-
公开(公告)号：KR1019910002630B1
公开(公告)日：1991-04-27
申请号：KR1019880008738
申请日：1988-07-14
IPC: H04M7/00
Abstract: The system forms a network between the level 3 unit and the level 2 unit to increase the handling capacity of the relay system and to decrease the signal transmission delay time. The level 3 units (410a-410m) are connected to a signal network supervising unit (450) through a level 3-3 network (400) and an indevendent control network (460). The level 2 units (4401-440k) are connected to the signal network supervising unit (450) through the level 2-3 networks (420a-420m) and distributive memory (430a-430k). An outer parallel bus is connected to the level 3 units and level 2 units regardless of the parallel bus intermediater. The message stored on the distributive memories (430a-430k) is transmitted to the level 3 units through the parallel bus.
Abstract translation: 该系统在3级单元和2级单元之间形成网络，增加中继系统的处理能力，降低信号传输延迟时间。 级别3单元（410a-410m）通过级别3-3网络（400）和独立控制网络（460）连接到信号网络监控单元（450）。 2级单元（4401-440k）通过2-3级网络（420a-420m）和分配存储器（430a-430k）连接到信号网络监控单元（450）。 外部并行总线连接到3级单元和2级单元，无论并行总线中间设备如何。 存储在分配存储器（430a-430k）上的消息通过并行总线传输到3级单元。
-
-
-
-
-
-
-
-
Search Results
29
records
(took 0.018 seconds)
