Abstract:
A system and a method for enhancing the saturation of an RGBW image signal are provided to increase the saturation of unmixed color by increasing the brightness of backlight and reducing the brightness of a white sub pixel at an RGBW display. An image signal classifier(103) uses image classification parameters depending on the brightness and saturation of an image signal to classify each frame of image signal according to image classification unit. A backlight brightness controller(104) increases the brightness of the backlight as to a frame which is the target of saturation increase, and a white sub pixel controller(105) reduces the brightness of the white sub pixel of the image signal by corresponding to the increased amount of the backlight brightness. An RGBW image signal converter(101) converts an RGB image signal into an RGBW image signal.
Abstract:
A method for selecting Rx mode in a dual receiver-based portable terminal is provided to stably receive signals without deterioration in receiving by adaptively selecting either single receiver mode or dual receiver mode according to a wireless environment. If the power of a portable terminal having two receivers is turned on, the portable terminal works in single receiver mode(S201). The portable terminal periodically measures the RSSI(Received Signal Strength Indicator), BER(Bit Error Rate), and CINR(Carrier Interference plus Noise Ratio) of a signal received in single receiver mode(S203). Then the portable terminal judges whether the currently measured RSSI is larger than or equal to the first threshold RSSI(S205). If not, the portable terminal transfers to dual receiver mode(S207). However, in case the present RSSI is larger than or equal to the first threshold RSSI, the portable terminal judges whether the present RSSI is larger than or equal to the second threshold RSSI(S209). If so, the portable terminal maintains single receiver mode. In case that the present RSSI is smaller than the second threshold RSSI, the portable terminal judges whether the average BER is smaller than a threshold BER(S211). If not, the portable terminal judges whether the present CINR is larger than a threshold CINR(S213). If so, the portable terminal maintains single receiver mode.
Abstract:
본 발명은 DMB 서비스 제공 방법 및 장치에 관한 것으로서, 본 발명의 방법은 무선 통신망 접속장치가 DMB 제공 서버로부터 DMB 데이터를 수신하는 제1 수신과정과, 상기 무선 통신망 접속장치가 무선 단말로부터 DMB 데이터 요청 메시지를 수신하는 제2 수신과정과, 상기 DMB 데이터 요청 메시지에 응답하여 상기 무선 통신망 접속장치가 대응된 DMB 데이터를 상기 무선 단말에게 전달하는 전달과정을 포함하고, 본 발명의 장치는 사용자의 요청에 응답하여 DMB 데이터 요청 메시지를 무선 통신망으로 전달하고 그에 응답하여 무선 통신망을 통해 전달된 DMB 데이터를 사용자에게 제공하는 무선 단말과, 외부의 DMB 서비스 제공 서버로부터 DMB 데이터를 수신하고 상기 DMB 데이터 요청 메시지에 응답하여 대응된 DMB 데이터를 상기 무선 단말에게 전달하는 무선 통신망 접속 장치를 포함하는 무선 통신 시스템인 것을 특징으로 한다. 따라서 본 발명은 DMB 서비스 제공을 위한 네트웍 부하를 최소화 할 수 있으며 DMB 서비스 제공시 과금 및 인증을 용이하게 할 수 있다.
Abstract:
본 발명은 CSMA/CA(carrier sense multiple access with collision avoidance)에 기반한 무선 랜에서의 매체 접근 제어 방법 및 그 장치에 관한 것으로, CSMA/CA에 기반한 무선 랜 시스템에서 단말들을 전송 우선 순위에 따라 다수개의 그룹으로 나누어 그룹마다 서로 다른 DIFS(DCF interframe space)를 할당하고, 같은 우선 순위의 그룹에 속한 단말의 경우에도 전송 우선 순위에 따라 서로 다른 백오프 타임을 할당하고, 매체 전송 경쟁시마다 각 단말이 할당받은 백오프 타임으로 재설정하여 경쟁함으로써 같은 우선 순위 그룹내에서도 전송 우선 순위가 높은 단말에게 확실한 전송기회를 보장할 수 있고, CSMA/CA에 기반한 무선 랜 시스템에서 전송 의사가 있는 단말의 개수와 무관하게 우선순위가 높은 단말의 전송 기회를 확실히 보장하며, 각 단말의 대기 시간이 서로 다르므로 충돌이 발생할 여지를 줄여 충돌에 의한 쓰루풋(throughput) 저하를 막을 수 있다. CSMA/CA, MAC, IEEE 802.11, 매체접근, 백오프타임, 우선순위, DIFS
Abstract:
전화선로 배가 시스템의 시그날링 처리회로에 관한 것으로, 특히 하나의 통신선로에 적어도 하나 이상의 통신터미널을 접속하여 동시에 전화통신을 할 수 있는 전화선로 배가 시스템의 시그날링 처리회로에 관한 것이다. 상기의 가입자 전화선로 배가 시스템의 시그날링 멀티플렉서는 프레임 동기신호(IDL SYNC)에 동기된 시스템 클럭(IDL CLK)을 2타임 슬롯 주기만큼 카운팅하여 "D"채널 인에이블제어신호(RCO)를 발생하는 D채널제어기(108)와, 상기 D채널 제어기(108)로부터 출력되는 "D"채널 인에이블신호(Q1)를 상기 클럭(IDL CLK)에 의해 제1 및 제2시프트하여 D1, D2데이터 출력제어신호(Q2)(Q3)를 출력하는 시프트 레지스터(114)와, 상기 시프트 레지스터(114)로부터 출력되는 D1, D2제어신호(Q2)(Q3)에 의해 각각 인에이블되어 제1,제2입력단자로 각각 입력되는 시그날링 데이터(D1)(D2)를 2B+D채널송신버스(IDL RX)의 "D"채널로 출력하는 전송게이트(120)와, 2B+D채널의 수신버스(IDL TX)로 입력되는 D채널의 시그날링 데이터(D1,D2)를 서로 다른 주기의 제1,제2전송제어신호(A)(B)의 입력에 응답하여 래치 출 력하는 시그날링 데이터 분리회로(154)와, 상기 D1출력제어신호(Q2)(122)의 출력을 논리곱하여 제1전송제어신호(A)를 출력하는 앤드게이트(124)와, 상기 시스템 클럭(IDL CLK)와 상기 D2출력제어신호(Q3)를 논리곱하여 제2전송제어신호를 출력하는 앤드게이트(126)을 구성된 데이터 클럭발생기(128)로 구성된다.
Abstract:
메모리 라이트 보호 회로에 있어서, 마이크로프로세서(10A)가 D-RAM메모리부(70A)를 억세스하는데 있어서 마이크로 프로세서(10A)로부터 발생되는 어드레스 신호와 메모리보호 제어신호로부터 TM기방지 제어 신호를 발생하고, 상기 마이크로프로세서(10A)의 출력 데이터에 대해 버스 콘트롤하며, 상기 쓰기방지 출력과 버스 제어출력이 모두 상기 D-RAM 메모리부(70A)의 라이트 제어신호일시만 라이트 제어신호를 발생한다.
Abstract:
3D 디스플레이를위한양안거리인식장치가개시된다. 그장치는, 기준양안거리(criteria pupil distance)에대응하는 3D 이미지를출력하는디스플레이부와, 3D 이미지를구성하는뷰 콘(view cone)을제어하는제어부와, 뷰콘의제어에따라 3D 이미지에아티팩트(artifact)가관찰되는지에관한사용자피드백을수신하는사용자입력부를포함한다. 제어부는, 뷰콘을기준양안거리에대응하는마진(margin) 내에서이동시킬수 있으며, 사용자피드백에기초하여, 기준양안거리를변경하거나, 기준양안거리를사용자의양안거리로결정할수 있다.