Abstract:
기저대역 기지국 및 단말기 모뎀 정합 장치는 기지국의 기저대역 모뎀 보드의 제1 인터페이스와 광 케이블로 연결되고, 단말기의 기저대역 모뎀 모드의 제2 인터페이스와 광 케이블로 연결되며, 제1 인터페이스와 제2 인터페이스 사이의 데이터 포맷 변환을 수행하여 기지국의 기저대역 모뎀 보드 및 단말기의 기저대역 모뎀 모드 사이에서 데이터를 송수신한다.
Abstract:
PURPOSE: A universal communication testing device and a communication device testing device thereof are provided to test the ground communication devices and the marine communication devices. CONSTITUTION: A testing unit(120) executes the modem verification or diagnosis monitoring of marine communication devices and ground communication devices using a clock signal. A transmission and reception matching unit(110) interfaces the ground communication devices and the marine communication devices for the modem verification and diagnosis monitoring. A switch unit(140) provides selection signals to test the operational control in the marine communication or the ground communication to a clock signal generation unit and the testing unit. [Reference numerals] (11) Base station / Coast station; (110) Transmission and reception matching unit; (12) Terminal / Ship station; (120) Testing unit; (130) Clock signal generation unit; (140) Switch unit; (20) General-purpose communication testing device; (30) Processor module; (40) Host PC
Abstract:
본 발명에서는, 서로 동일한 n(자연수)개의 핀 수를 갖는 제1 및 제2 필드 프로그래머블 게이트 어레이(Field Programmable Gtae Array: FPGA) 칩과, 상기 제1 FPGA 칩과 연결되는 제1 주변블록들 및 상기 제2 FPGA 칩과 연결되고, 상기 제1 주변블록들과 대칭되는 제2 주변블록들을 포함하여 하나의 유닛으로 모듈화된 FPGA칩이 개시된다. 본 발명에 의하면, FPGA 칩을 모듈화함으로써, 모듈화된 각 회로 블록별로 개별적인 테스트가 가능하다. 또한, FPGA 칩 교체시 소켓이나 아답터를 사용하여 FPGA 칩을 교체하는 종래와는 달리 FPGA 칩을 모듈화함으로써, FPGA 칩 교체시 인접한 다른 부품들의 손상을 방지하고, Rework 작업에 따른 추가비용을 절감하고, 소켓이나 아답터가 필요치 않으므로, 비용 및 원가를 절감할 수 있다. IMT-Advancde, 이동통신 시스템, 기저 대역, FPGA
Abstract:
PURPOSE: An RF receiver of a 3G LTE mobile communication system, transmitter, and transceiver which uses direct conversion are provided to convert a high frequency carrier band signal in order not to pass through a intermediate frequency band. CONSTITUTION: An I/Q demodulator(333) demodulates an output signal of a band pass filter into I/Q(In-phase/Quadrature-phase). Reception end gain amplifiers control the gain of the output signal of the I/O demodulator. A low pass filter(336) selectively passes through the band of a predetermined channel. Reception end differential amplifiers amplify the band of the predetermined channel.
Abstract:
본 발명은 기지국 및 단말기를 정합하는 정합 장치와 그 방법에 관한 것이다. 본 발명에서는, 적어도 하나의 접속기(Connector)를 이용하여 기지국 및 단말기를 유선으로 연결한다. 그리고, 연결된 기지국으로부터 출력되는 적어도 하나의 신호를 수집한다. 이어, 수집된 신호의 크기를, 신호 변환기의 변환 비트 수를 기준으로 소정 크기 변환한다. 그리고, 크기 변환된 신호를 단말기로 전달한다. 또한, 단말기로부터 출력되는 적어도 하나의 신호를 수집한 후, 수집된 신호의 크기를 신호 변환기의 변환 비트 수를 기준으로 소정 크기 변환시킨다. 그리고, 크기 변환된 신호를 기지국으로 전달한다. 이를 통해, 단말기 및 기지국간의 연동 시험을 안정적으로 수행할 수 있으며, 오류 발생시 그 원인을 정확히 분석하여 그로 인한 단말기 개발 일정 단축 및 비용 절감을 이룰 수 있다. 단말기, 기지국, 정합, 모뎀, 연동, 신호 변환기, 개발 시간, 비용
Abstract:
An apparatus and a method for matching a base station with a terminal are provided to connect the terminal with the base station by cable when at least one of the terminal and the base station does not normally operate, thereby stably performing a connection test between the terminal and the base station. The first connector collects a signal outputted from a base station(200). The second connector collects a signal outputted from a terminal(300). A signal controller(150) converts the size of the signal collected through the first connector and provides it the second connector. The signal controller converts the size of the signal collected through the second connector and provides it the first connector. A header(140) receives matching information including at least one of frame synchronization and a frame number from the base station and transmits the matching information to the signal controller. The third connector transmits the matching information to the terminal.
Abstract:
An apparatus and a method for testing a terminal are provided to shorten the development time and achieve a cost-saving effect by notifying whether or not a terminal is in a normal state in an online environment where a base station exists. A host computer(201) confirms whether or not a base station that transceives data with a terminal exists. In the case of an offline at which the base station does not exist, the host computer generates a verification signal for testing a modem state of a terminal. An offline transmission test unit(203) converts the generated verification signal into a certain format signal. The converted verification signal is provided to the terminal. In the case of an online mode where the base station exits, the state information is collected.
Abstract:
PURPOSE: A selective UTOPIA(Universal Test operations PHY Interface for ATM) level 1 matching apparatus in an ATM system, and an implementing method thereof are provided to select one physical layer device and match it with an ATM layer device to thereby implement them with a simple structure at a low cost. CONSTITUTION: An ATM layer(10) includes devices handling segmentation and assembly of ATM cells. The first physical layer(30) is matched with a UTOPIA level 1 and transmits data at the first speed to an optical cable. The second physical layer(40) is matched with the UTOPIA level 1 and transmits data at the second speed to a twist pair cable. A physical layer selector(20) selects one physical layer according to a physical layer select signal received from the outside, and matches the selected physical layer with the ATM layer(10).