Abstract:
일 실시예에 따른 엑스선 영상 장치는, 엑스선을 조사하는 엑스선 소스; 디스플레이부; 엑스선 촬영 조건에 대응되는 산란 방사선(Stray Radition)의 3차원 분포 데이터를 획득하고, 상기 엑스선 소스와 엑스선 디텍터의 상대적인 위치 정보와 상기 획득된 산란 방사선의 3차원 분포 데이터를 이용하여 산란 방사선 분포 영상을 생성하고, 상기 디스플레이부를 제어하여 상기 생성된 산란 방사선 분포 영상을 표시하는 제어부;를 포함한다.
Abstract:
본 발명은 통신 시스템에서의 IP 관리를 위한 연결 제어 방법에 대한 것으로, 기지국과 패킷접속라우터 간의 제1 트래픽 연결을 설정하고, 상기 기지국과 사용자 단말간의 상량 링크 및 하향 링크 제2 트래픽 연결을 설정하고, 상기 제1 트래픽 연결 및 상기 제2 트래픽 연결을 통해 IP 관리 메시지를 전달한다. IP관리 연결 제어, Transport CID
Abstract:
본 발명은 무선 휴대 인터넷 시스템(HPI)에서의 호 처리 통계 데이터 수집 장치 및 방법에 관한 것이다. 본 발명의 시스템의 운용 및 관리를 하는 운용 관리 서버, 호 처리 통계 데이터를 저장하는 제 1 MIB(Management Information Base) 및 SNMP 메시지를 생성하는 SNMP 매니저를 포함하고, 호 처리 통계 데이터 수집 요청 및 수집 데이터의 전송 요청을 하는 NMS(Network Management System); 및 기지국의 운용 및 관리를 하는 운용 관리 모듈, 기지국 별로 호 처리 통계 데이터를 저장하는 제 2 MIB 및 NMS로부터 전송받은 SNMP 메시지를 처리하는 SNMP 에이전트를 포함하는 기지국을 포함한다. 이러한 본 발명에 따르면, 동작 중에 성능 데이터를 수집할 수 있게 하고 효율적인 네트워크 망을 관리할 수 있는 SNMP를 이용한 무선 휴대 인터넷시스템을 제공하는데 있다 HPI, 호 처리, SNMP, MIB
Abstract:
본 발명은 망 관리 시스템 및 기지국을 포함하는 고속 휴대 인터넷 망(High-Speed Portable Internet Network)에서의 관리자 명령 인증 장치 및 그 방법에 관한 것이다. 본 발명에서는, 먼저 관리자로부터 입력되는 명령이 고속 휴대 인터넷 망 운용에 치명적인 영향을 미치는 운용 명령인지 또는 일반적인 정보 요청 명령인지를 확인한다. 확인 결과, 운용 명령이면 그에 따른 객체 식별자(Object Identifier)와 기지국 단위로 사전 할당한 고유 인증 키 값을 포함한 메시지를 생성하여 기지국으로 송신한다. 그러면, 기지국은 수신된 메시지 내의 고유 인증 키 값과 사전 할당 받은 고유 인증 키 값을 상호 비교한 후, 비교 결과 동일하면 사전 할당받은 고유 인증 키 값을 폐기 처리함과 동시에 새로운 고유 인증 키 값을 생성한다. 그리고, 수신된 메시지 내의 운용 명령을 수행한 후, 그에 따른 결과를 망 관리 시스템으로 보고한다. 이를 통하여, 악의적인 관리자에 의한 시스템 기능 변조를 사전에 차단할 수 있다. 고속 휴대 인터넷 망, 망 관리 시스템, 기지국, 메시지 인증, 고유 인증 키
Abstract:
본 발명은 휴대 인터넷 시스템의 기지국 재시동 원격제어 방법에 관한 것이다. 본 발명은 상기 휴대 인터넷 시스템의 망관리서버가 상기 기지국의 특정 프로세서재시동을 위한 재시동 요구메시지를 구성하여 상기 기지국의 특정 프로세서로 전송한 후, 상기 재시동 요구메시지를 전송하고, 응답대기를 위한 타이머를 구동시키고, 상기 타이머가 종료되기 전에 상기 기지국의 특정 프로세서로부터 응답 메시지를 수신하여 기지국의 재시동 시킨다. 본 발명에 의하면, 기지국의 특정 프로세서가 비정상적으로 동작하거나, 소프트웨어 업그레이드 등을 위해 직접 원격지 시스템을 방문하지 않아도 되도록 하여 인력 및 시간낭비를 줄이고, 효율적인 시스템 관리가 가능하게 된다.
Abstract:
PURPOSE: A locking device for an actuator of an HDD(Hard Disk Drive) is provided to improve reliability of the locking device for fixing a head of the actuator to a parking area. CONSTITUTION: A beam(30) is formed on a molding unit supporting a voice coil(77) at a rear end of an actuator(70). A locking device is formed on a fixed location of the beam. Herein, the locking device forms a protruded sill(15) at a lower end of a locking lever(10) installed around a hinge shaft(28). The locking lever is installed around the hinge shaft for being supported by tension springs(21,23). Moreover, a damper(17) is installed on the beam. By applying a current to the voice coil, the coil is moved by a magnetic field of a magnet. The actuator is rotated about a pivot shaft(72) for a head(61) to record and reproduce data on a track of a disk. By the head at the outermost location, the beam contacts to a stop wave for preventing replacement to the outer side.
Abstract:
본 발명은 하드디스크 드라이브의 가요성 인쇄회로(FPC) 연결장치에 관한 것으로, 특히 HDD의 액츄에이터에 설치된 자기헤드와 인쇄회로기판 사이에 연결되어 신호전달을 위한 가요성 인쇄회로의 바이어스힘을 없애기 위한 연결장치에 관한 기술이다. 하드디스크 드라이브의 액츄에이터에 설치된 자기헤드의 신호케이블이 연결된 프리앰프와 본체베이스상의 인쇄회로기판과 연결된 가요성 인쇄회로를 연결하기 위하여 본체 베이스에 돌출되게 형성된 보스에는 홀을 형성하고, 상기 보스에 엑츄에이터의 피벗베어링을 끼워 회전가능하도록 상부중앙에 와이어홀이 형성된 피벗스크류를 고정하고, 상기 본체베이스에 인쇄회로기판과 연결된 가요성 인쇄회로를 고정시키고 상기 프리앰프와 가요성 인쇄회로간에는 연결용 와이어로 피벗스크류의 와이어홀과 보스의 홀을 통과시켜 각각 와이어를 프리앰프와 가요성 인쇄회로와 연결하여 액츄에이터가 회전의 자기헤드에 영향을 주던 가요성인쇄회로의 바이어스힘을 없앨 수 있게 되므로 자기헤드가 특정 트랙을 찾을 때 오차 요인을 줄일 수 있는 것이 .
Abstract:
A method for a termination call is provided to enable a terminal to perform a receiving voice call with a VoIP by adding a VoIP receiving service even when a terminal is in an idle mode. When a receiving call occupancy request for a terminal(100) at an idle mode is transmitted from a VoIP(Voice over Internet Protocol) server(500), a request for the occupancy of a receiving call is notified to the terminal(S101-S104). If a ranging request is inputted from the terminal, the idle state of the terminal is released(S105-S110). A terminal registration processing procedure for network re-entry is performed(S111-S120). A receiving call is set up so that the terminal for which registration is processed may receives a voice packet network service(S118,S119).
Abstract:
An IP management connection control method in a mobile communication system is provided to effectively use resources of a base station without establishing any additional connection. A base station establishes initial ranging(S210), and the base station sets basic transmission capability of a terminal(S220). The base station authenticates the user terminal and performs authentication key exchange(S230), and the base station performs user terminal registration(S240). The base station establishes uplink and downlink traffic connections(S250).
Abstract:
A method for producing a status function matrix in a base station and a call connection control method using the same are provided to improve a call connection control processing rate by using a two dimensional status function matrix having a status function as an element without using if-then-else or case commands. An ACS(Access Point Control Subsystem) receives a message from an AT(Access Terminal) and an ATS(Access Point Traffic Subsystem). The ACS calls a status function corresponding to the transmitted message and a current call status among plural status functions respectively mapped to plural elements of a status function matrix, and performs the called status function. In the status function matrix, a call status is one index of a column and a row. Plural messages are the rest one index of the column and row.