-
-
-
-
-
公开(公告)号：KR1019950001434A
公开(公告)日：1995-01-03
申请号：KR1019930011954
申请日：1993-06-29
Applicant: 주식회사신도리코
Inventor： 윤길규
IPC: G03G21/00
Abstract: 본 발명은 토너를 이용하여 현상하는 복사기등의 기기에서 폐토너 만배를 검지하는 방법에 관한 것으로, 특히 토너보급 횟수를 체크하여 폐토너 만배여부를 판단하는 폐토너 만배검지를 위한 제어방법에 관한 것이며, 폐토너 만배여부를 기존의 방법과는 달리 소프트웨어적으로 판별하되, 토너의 보급량, 즉 토너보급 횟수를 체크하여 미리 정해진 일정횟수에 도달했을 때, 사전에 경고하는 의미로 소정의 LED를 점멸시키면서 그로 부터 일정 매수까지만 복사가 가능하도록 하고, 상기 일정 매수가 복사될 때까지도 폐토너가 회수되지 않으면, 더 이상 복사동작을 수행할 수 없도록 하기 위하여 해당기기를 정지시킴으로서, 기기 전체적의 구조를 단순화하여 필요공간 및 제작비용을 현저하게 감소시키고, 기존의 오검지에 의한 오동작 등을 배제시켜 동 상의 신뢰도를 제고시키는 효과를 갖는다.
-
Patent Agency Ranking
-
-
公开(公告)号：KR1019960006816B1
公开(公告)日：1996-05-23
申请号：KR1019930011954
申请日：1993-06-29
Applicant: 주식회사신도리코
Inventor： 윤길규
IPC: G03G21/00
Abstract: checking whether a flag for toner recovery is turned on; inputting a value of a white part of a drum read from a P sensor and a pattern value; checking that a value obtained in dividing the pattern value by the value of the white part of the drum, is over a predetermined value; if the value is over the predetermined value, increasing a counting value of the toner, turning on a LED of the Toner End, setting up a state memory flag, and stopping operating a main motor; if the value is below the predetermined value, confirming the pattern value read from the P sensor, confirming whether the toner is added or not, and checking the state memory flag of the toner; if the flag is turned on, increasing the counting value by 1 and repeating the above steps till a given time; if the time is over, turning off the LED, setting up the number of coping operations; and finishing the copy operations by turning off the LED, stopping operating the main motor, making the flag for toner recovery at on, and turning off power.
Abstract translation: 检查墨粉回收标志是否打开; 输入从P传感器读取的滚筒的白色部分的值和图案值; 检查将图案值除以滚筒的白色部分的值所得到的值是否超过预定值; 如果该值超过预定值，增加调色剂的计数值，打开碳粉末端的LED，设置状态存储器标志，并停止操作主电动机; 如果该值低于预定值，则确认从P传感器读取的图案值，确认调色剂是否被添加，并且检查调色剂的状态存储标志; 如果标志被打开，则将计数值增加1并重复上述步骤直到给定时间; 如果时间结束，关闭LED，设置应对操作次数; 并关闭LED，停止操作主电机，使墨粉回收标志为开，并关闭电源，完成复印操作。
-
公开(公告)号：KR1019940005133B1
公开(公告)日：1994-06-11
申请号：KR1019910019037
申请日：1991-10-25
Applicant: 주식회사신도리코
Inventor： 윤길규
IPC: G03G15/04
Abstract: The recognition method which does not use the sensors attached to the paper cassette or the size setting switches has the regist sensor (6) locating the paper transmitted by the seperation pad (3) and the roller (2) via the upper/lower guider (4,5) to find out whether the paper is jammed or not. The size of recopy paper is also detected by counting clocks from the time when a sheet of paper is detected by the regist sensor (6) to the time when the paper is moved out.
Abstract translation: 不使用附接到纸盒的传感器或尺寸设定开关的识别方法具有登记传感器（6），通过上/下导向器（6）定位由分隔板（3）和辊（2）传送的纸张 4,5）找出纸张是否卡住。 复印纸的大小也可以通过计数从纸张传感器（6）检测到纸张到纸张移出时的时间来计数时间。
-
公开(公告)号：KR1019940003114B1
公开(公告)日：1994-04-13
申请号：KR1019910019035
申请日：1991-10-25
Applicant: 주식회사신도리코
Inventor： 윤길규
IPC: G03G15/00
Abstract: The device freely chooses a lower cassette layer with a paper selection key in the case of absence of paper while a manual paper feeding door is open. The device includes a manual paper feeding door sensor (7) which detects whether the door is open or not, a copying paper sensor (8) which detects whether or not copying papers are on the table, a cassette sensor (9) which detects the setting state of cassette, a sensor output means (6) which generates the sensor output, an input-output interface means (4) which transfers sensor scan signal to the sensors (7,8,9), a central control means (2) which controls the usage of cassette layers, a memory means (3) which connects to the data bus, and an operating panel (1) which displays the operating state.
Abstract translation: 在手动供纸门打开的情况下，在没有纸张的情况下，设备可自由选择带有纸张选择键的下层纸盒层。 该装置包括检测门是否打开的手动给纸门传感器（7），检测复印纸是否在桌子上的复印纸传感器（8），检测纸张传感器 产生传感器输出的传感器输出装置（6），将传感器扫描信号传送到传感器（7,8,9）的输入输出接口装置（4,8），中央控制装置（2） 控制盒层的使用，连接到数据总线的存储装置（3）和显示操作状态的操作面板（1）。
-
-
-
-
-
-
-
-
-
Search Results
26
records
(took 0.017 seconds)
