Abstract:
A differential varactor is provided to improve common mode rejection ratio by forming gate varactor as a differential varactor. A first input terminal is connected with a source electrode of a first and a third gate varactor through a first and a third capacitor. A second input terminal a source of the second and fourth varactor through a second and fourth capacitor commonly. A source electrode of the first and the second gate varactor supplies positive bias voltage through a third and a fourth resistor(R3,R4). A source electrode of the third and fourth gate varactor supplies negative voltage through a fifth and a sixth resistor.
Abstract:
본 발명은 스타트업(start-up)모듈 및 이를 이용한 바이어스 전원공급장치에 관한 것으로, 기준전압발생기내 하이임피던스를 가지는 특정노드의 전압이 초기 전원공급시 제로상태에 빠지는 것을 막기 위하여 상기 특정노드의 전압을 체크하여 제로상태인지 정상동작상태인지를 판별하는 판별부와, 상기 판별부로부터 판별된 결과값에 따라 상기 특정노드의 전압이 정상동작 전압값으로 회복될 수 있도록 구동전류를 생성하는 전류구동부를 포함함으로써, 기준전압발생기의 동작점이 제로(zero)상태로 되는 것을 방지하고, 빠른 시간내에 정상상태를 유지할 수 있도록 한다. 아울러 본 발명은 전력 소모가 적을 뿐만 아니라 단순한 회로구성과 저전압 동작이 가능하여 낮은 공급전원 시스템에도 적용할 수 있는 효과가 있다. 바이어스 전원공급장치, 밴드갭 기준전압발생기, 스타트업모듈, 판별부, 전류구동부
Abstract:
A method of blocking network attacks using information included in a packet, and an apparatus thereof are provided. The method includes: receiving a packet containing information on the packet including at least information on a source from which the packet is sent, and information on a destination to which the packet is sent; and extracting the information on the packet included in the packet, comparing the information with a predetermined access control condition, and blocking or passing the packet. By doing so, a packet being transferred with a routing header capable of bypassing a security device as in an Internet Protocol version 6 (IPv6) network can be appropriately blocked or passed. Accordingly, security problems caused by the routing header can be overcome, and as a result, usage of the routing header can be promoted. Also, since a routing header can be used for transmitting a packet along a desired path, the routing header can be widely used without security problems, and can ease network security concerns relating to IPv6 networks that are expected to come into increasingly wide use.
Abstract:
스트라이핑(Striping) 기법을 이용한 RAID(Redundant Array of Inexpensive(or Independent) Disks) 시스템에서의 데이터 재구성 방법을 개시한다. 본 발명은 스트라이핑 기법을 이용하여 데이터를 저장하는 시스템에서 디스크가 추가되는 경우, 데이터를 즉시 재구성하지 않고 쓰기 연산이 발생한 블록에 대해서만 재구성 과정을 수행하는 것을 특징으로 한다. 본 발명에서는, 디스크를 추가한 후 데이터 쓰기 연산이 요청되면 재구성된 후의 위치를 계산하여 그 위치에 데이터를 기록한다. 만일, 기록하고자 하는 위치에 다른 데이터가 존재한다면 그 데이터에 대해서도 재구성된 후의 위치를 계산하여 그 위치에 데이터를 기록한다. 최악의 경우, 요청된 블록에 대해 연쇄적으로 발생하는 재구성 블록의 수가 커지는 경우도 발생할 수 있으나, 이러한 연산 과정을 통해 일반 디스크 I/O에 대한 요청을 금지시키는 시간이 매우 짧아지며, 요청 빈도수가 높은 데이터에 대해 미리 재구성을 수행할 수 있는 효과를 가진다.
Abstract:
본 발명은 논리 볼륨 관리 시스템에서 무정지 서비스를 제공함에 있어서, 스냅샷 생성 후 수행되는 쓰기 연산시 COW(Copy-on-Write)의 필요성 판단과 스냅샷 삭제 연산 시의 COW 발생여부를 판단하기 위해 필요한 디스크 I/O의 수를 현저히 줄임으로써, 시스템의 성능 향상 및 데이터 엑세스 서비스의 신뢰성을 도모할 수 있는 논리 볼륨 관리 시스템에서의 매핑 테이블 구조를 구비한 논리 볼륨 관리 시스템 및 이를 이용한 효율적인 스냅샷 방법에 관한 것이다. 본 발명의 매핑 장치는 각 논리 데이터 블록 또는 익스텐트에 대하여, 원본 볼륨을 위한 매핑 정보와 각 스냅샷을 위한 매핑 정보를 한 쌍으로 연결하여 하나의 매핑 엔트리로 구성하는 구조로 이루어진다.
Abstract:
PURPOSE: A mapping table structure of a logical volume management system and an efficient snapshot method using the same are provided to offer a reliable service while keeping a mapping time regardless of the existence of a snapshot, and improve system performance by reducing a number of the disk I/O(Input/Output) to one. CONSTITUTION: The mapping table structure comprises one entry(550) for each logical data block(560) by connecting the original volume mapping information(510), the first snapshot mapping information(520), the second snapshot mapping information(530), and the third snapshot mapping information(540) to one pair. Each mapping information comprises the pair of a disk ID(570) for discriminating various physical disks joining in the volume and a physical block ID(580) in the disk.
Abstract:
PURPOSE: An automatic tuning system of a continues time filter is provided to implement a reliable filter by maintaining a constant conductance value since the changed value matches with the external stable clock through a phase locked loop. CONSTITUTION: An automatic tuning system of a continuous time filter includes a voltage controlled oscillator. The apparatus utilizes a phase locked loop provided with a phase and frequency detector, a charge pump, a low band pass filter and a voltage controlled oscillator. The voltage controlled oscillator includes an input voltage control block(300), a transconductor(304), a plurality of capacitors(306), a comparator(308) and a signal shaping block(310). The input voltage control block(300) performs a switching so as to alternatively input the first and the second input voltages to the first plus input terminal and the first minus input terminal. The transconductor(304) generates a differential voltage through the plus output terminal and the minus output terminal in response to the voltage difference of the first input voltage and the second input voltage. The plurality of capacitors(306) generates an integral voltages by charging the charges with receiving the differential output current. The comparator(308) compares the sizes of the integrated voltage and generates the input voltage control signal based on the compared result. And, the signal shaping block(310) makes the input voltage control signal a predetermined shape and outputs the control signal to the input voltage control block(300).
Abstract:
PURPOSE: A RAID(Redundant Arrays of Inexpensive Disks) sub system and a method for inputting/outputting and recovering data on a degraded mode by using the same are provided to increase a response speed of a system on the degraded mode, and to decrease the system load according to operation by inputting/outputting the data requested from a host computer as using a block of a sparing disk drive. CONSTITUTION: The system comprises a disk array controller(200) connecting to a host terminal(100) and a disk array(210) through a bus, and the disk array(210) including disk drives(211-214) and the sparing disk drive(215). The disk array controller(200) distributes and stores the data in the disk drives(211-214), processes the input/output parallel, and processes the input/output of the data to be inputted/output from the degraded disk through the sparing disk drive(215). The sparing disk drive(215) includes a sparing disk recovery bitmap checking the recovery of the sparing disk blocks, and recovers the block of the degraded disk drive according to the data input/output request of the host computer(100).
Abstract:
PURPOSE: A concurrency controlling method is provided to enhance a concurrency of a search or an insertion operation by updating a split and an MBR(Master Boot Record) operation so that it can satisfy a request condition of a commercial DBMS(Database Management System), for example, a contents based image search. CONSTITUTION: The method comprises steps of finding a terminal node appropriate for inserting a new entry into(S501), giving back a path stack, storing the path from a root to a found terminal node, an exclusive lock and a shared latch on the found terminal node, and checking if there exists a space at the found node for inserting the new entry into(S502), releasing a shared latch of the terminal node and obtaining an exclusive latch(S503), inserting the entry into the found terminal node(S504), checking if an MBR is changed by the insertion of the entry(S505), releasing the exclusive latch of the terminal node(S506), reflecting the release of the exclusive latch of the terminal node on ancestor nodes stored at the path stack(S507), releasing all the latches and locks(S508), in a case that there is no space in the step S502, obtaining a tree lock, recording an NTA start, performing a split operation, recording a dummy CLR and releasing all the latches and locks(S509, S510, S511, S512, S508).
Abstract:
본 발명은, 파편화된 데이터베이스 시스테에서의 제한점을 이용한 동적 결합 최적화 방법에 관한 것으로, 사이트의 부결합 관리기가 원격 부결합 모니터를 통하여 접수된 부결합을 부결합 결과 모니터에 전송하며 파편의 인덱스를 초기화하고, 부결합에 대한 제한점을 설정하는 제1단계: 상기 부결합 결과 모니터가 부결합의 제한점을 이용하여 튜플 결합기를 제어하여 파편들간의 튜플 결합을 실행시켜 결과물을 누적시키고, 파편의 인덱스를 조정하며 마지막 튜플간의 결합인지를 확인하는 제2단계; 마지막 튜플간의 결합이면 부결합을 요구한 사이트로 부결합의 결과물 누적치를 전송하는 제3단계; 및 마지막 튜플간 결합이 아니면 결과물 누적치가 제한점을 초과하는지를 확인하여 부결합을 요구한 사이트로 파편의 인덱스, 결과물 누적치 및 유효하지 않은 파편을 전송하는 제4단계를 포함하며, 통신망을 이용하여 한 번 전송된 파편은 재전송되지 않으므로 결합 처리시의 전송 비용을 줄일 수 있고, 부결합을 이주시킬 때 파편의 지시자들과 부결합의 중간 실행 결과를 같이 전송할 수 있으며, 부결합의 중복 실행을 방지함으로써 결합 처리시의 처리 시간 및 응답 시간을 줄일 수 있는 효과가 있다.